“I’m Not Dead Yet!”

No Comments on “I’m Not Dead Yet!”



No, the D20 is not dead yet.  Earlier sources had reported the death of this die, but it has rallied into a viable project once again. The 3D printer failed spectacularly with a clogged nozzle that required disassembly and cleaning.  After our lab techs adjusted the printer bed I gave the die another try and it worked!  There was much rejoicing!

One half is done, in a nice green.  The second half should be printed later today which is a good thing because the electronic parts I ordered for this project were delivered today!


Leave a Reply

Your email address will not be published. Required fields are marked *